Doomworld Forums - Texture selection in Strife mode

Doomworld Forums : Powered by vBulletin version 2.2.5

Doomworld Forums > Special Interest > Doom Builder > Texture selection in Strife mode

Author

All times are GMT. The time now is 19:51.

WildWeasel
Resident Castlevania Super-Fanboy

Posts: 1730
Registered: 07-03

When making a map for ZDoom (Strife in Hexen) format, I make a few sectors, build the nodes, go into 3D mode, and attempt to open the texture selector. But the selector immediately crashes Doom Builder. It doesn't seem to matter if I turn off Mix Flat/Texture Resources.

06-13-05 17:36 #

Profile || Blog || PM || Homepage || Search || Add Buddy

Report to mod || IP || Edit/Delete || Quote

CodeImp
Moderator

Posts: 1102
Registered: 12-03

Tried it, works for me. But I used Doom2.wad as IWAD, I dont have Strife. If the IWAD doesnt matter then something else must be wrong, please provide enough information for me to find the bug.

__________________
Doom Builder 2 is coming!

06-13-05 17:49 #

Profile || Blog || PM || Homepage || Search || Add Buddy

Report to mod || IP || Edit/Delete || Quote

Enjay
ASK ME ABOUT FOOTBALL / STEAM / DEAD CELEBRITIES / THE BLAIR WITCH PROJECT

Posts: 3989
Registered: 12-00

I believe there may be a slight difference in the TEXTURE1 or maybe the PNAMES lump structure in strife versus Doom. Perhaps that is causing the problem?

06-13-05 18:26 #

Profile || Blog || PM || Email || Homepage || Search || Add Buddy

Report to mod || IP || Edit/Delete || Quote

Graf Zahl
Forum Legend

Posts: 4321
Registered: 01-03

CodeImp said:
Tried it, works for me. But I used Doom2.wad as IWAD, I dont have Strife. If the IWAD doesnt matter then something else must be wrong, please provide enough information for me to find the bug.

You can also use the shareware WAD. It uses the same different lump format. But this should be all you need:

code:

typedef struct
{
	short	originx;
	short	originy;
	short	patch;
} strifemappatch_t;


typedef struct
{
	char		name[8];
	WORD		Flags;			
	BYTE		ScaleX;			
	BYTE		ScaleY;			
	short		width;
	short		height;
	short		patchcount;
	strifemappatch_t patches[1];
} strifemaptexture_t;

06-13-05 20:17 #

Profile || Blog || PM || Email || Homepage || Search || Add Buddy

Report to mod || IP || Edit/Delete || Quote

All times are GMT. The time now is 19:51.

Doomworld Forums > Special Interest > Doom Builder > Texture selection in Strife mode

Show Printable Version |

Email this Page |

Subscribe to this Thread

Forum Rules:

You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

HTML code is OFF
vB code is ON
Smilies are OFF
[IMG] code is ON

< Contact Us - Doomworld >