Ok, so I'm having a frustrating issue. I want a row of doors along the same wall all to open to the same room. I made two line defs the length of the wall, cut it into alternating 64s and 32s (the 32s are spaces inbetween the doors). I programmed each door the same way (15631) and none of them will open. They make the opening and closing sound and also move up maybe a few pixels. If I make each door individually they work properly, but placing the bits of wall inbetween them seems to screw them up. I've not had a single issue with doors until this point and I just can't figure it out.
Ok, so I'm having a frustrating issue. I want a row of doors along the same wall all to open to the same room. I made two line defs the length of the wall, cut it into alternating 64s and 32s (the 32s are spaces inbetween the doors). I programmed each door the same way (15631) and none of them will open. They make the opening and closing sound and also move up maybe a few pixels. If I make each door individually they work properly, but placing the bits of wall inbetween them seems to screw them up. I've not had a single issue with doors until this point and I just can't figure it out.
What am I doing wrong?
Share this post
Link to post