3d mode bug

[stewboy]

Ok. I'm editing a level in 3d mode. Then when I press 'w' to exit, it exits, then goes back in 3d mode again. etc, etc. The only way I can stop is to press 'w', then quickly press the 'close' button at top right hand corner, then save and close. Once this is done it tries to go into 3d mode once again, fails, gives an error message and quits.

[Kinkyfriend]

stewboy said:

Ok. I'm editing a level in 3d mode. Then when I press 'w' to exit, it exits, then goes back in 3d mode again. etc, etc. The only way I can stop is to press 'w', then quickly press the 'close' button at top right hand corner, then save and close. Once this is done it tries to go into 3d mode once again, fails, gives an error message and quits.

Happens to me, annoyance level is 10/10.
Try to save often so it won't make you lose important changes... My tip till someone meaning (Gherkin) fixes this issue :)

[iori]

Just don't tap W repeatedly, and always wait for the 3d window to open/close before you press W again.

[The Flange Peddler]

iori said:

Just don't tap W repeatedly, and always wait for the 3d window to open/close before you press W again.

I used to get this problem a lot, and that was my hunch about it too - accidently tapping 'W' twice before the switch to/from 3dmode would cause it just to keep going back and forth.

I haven't actually had any problems with this bug for quite a while though. Not sure why, but I did switch from the fullscreen 3d mode to the windowed 3d mode some time back, maybe it was then that I stopped having the problem.

[RICH-WADS]

it once happened to me

just be arful with 3d mode dont over use it and texture things too fast and ect

[entryway]

It happened to me too. Not once.