Norgath Posted January 11, 2009 I installed Doom Builder. The engine I need to use is GZDoom so I downloaded that along with the .cfg files which I put in the Doom Builder installation directory. When I attempt to start a new project I get an error after the initial configuration: WARNING: You have no IWAD file set for this configuration! WARNING: Could not find required lump PLAYPAL I did put the DOOM2.WAD in the Doom Builder directory. What did I do wrong? 0 Share this post Link to post
Patrick Posted January 11, 2009 you need to specify the path in the editor. that or your copy of Doom 2 doesnt work 0 Share this post Link to post
Dreadopp Posted January 11, 2009 Load up Doom Builder and click on "Tools" on the top task bar. Then go to configuration. Click on the tab marked "Files". Look for and click on Doom 2. Then you need to click browse and navigate to where your Doom2.wad is located (in this case, your Doom Builder folder). Click OK and it should work. 0 Share this post Link to post
Norgath Posted January 11, 2009 I get 'Runtime error: Subscript out of range' EDIT: Thanks for the help guys, it turns out I had a corrupt version of Doom2.wad. 0 Share this post Link to post