Jump to content
Search In
  • More options...
Find results that contain...
Find results in...
th3malleus

Textures where they shouldn't be...

Recommended Posts

After looking exhaustively I couldn't find an answer to my problem so here goes.

http://s1002.photobucket.com/albums/af149/th3malleus/

These four pictures show a room I made in doom builder, that utilizes some (poor) custom texturing. If you notice, near the right hand wall (Pictures 3-4) there is a point where the textures bleed into each other at the floor. In picture 1, near the waterfall the same issue occurs. However, this one will only occur when looking at the waterfall from behind. For reference the water in the middle is not deep water.

This wad is using zDoom as a source port.

Any ideas?

Share this post


Link to post
Guest DILDOMASTER666

Looks like an unclosed sector to me.

Share this post


Link to post

I see... The problem appears to be the location of the lines and when they cross other lines, weird things seem to happen.

Share this post


Link to post

Crossing other lines? Sounds like you have overlapping sectors - that tends to confuse the game engine, un-crossing the lines should fix it.

Share this post


Link to post

If you're using Doom Builder, press F4 to run a map analysis. It often (if not always) finds these kinds of problems for you.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×