Using Slade3

[Mr. T]

Is there a step by step guide somewhere to using SLADE to insert a texture into a vanilla pwad? I've searched but can only find general tuts, ones for ZDoom and some for XWE, which is bit too... 1996 for me to use.

Pretty please :-(

[Gez]

If you mean a TEXTUREx texture, then the editor is not finished yet.

A TX_ texture, or a flat, is a lot simpler.

[Mr. T]

OK, but does that work for boom, vanilla etc?

What editor would you recommend?

[Gez]

TX_ textures do not work in vanilla or Boom. (Though they're supported by many ports, including PrBoom+, Doomsday, Eternity and ZDoom.)

Flats work everywhere.

Personally I recommend SLumpEd as long as SLADE3 is not out of beta.

[Mr. T]

OK, is there a step by step tut anywhere? I have searched and can't find anything

[GreyGhost]

This is probably as close as you'll get, it's for a modified Legacy engine so some of the content's not relevant - such as the section on animated textures.

[Mr. T]

GreyGhost said:

This is probably as close as you'll get, it's for a modified Legacy engine so some of the content's not relevant - such as the section on animated textures.

Thanks, but I saw that already. could someone here who is familiar with the software please write one for slumped then?