flubbernugget Posted July 16, 2010 I'm not sure how much help this is but it is possible to make a perfect circle using Boris's Staircase Builder. Place 2 lines directly on top of each other (the length of these lines is the diameter of the circle). Then go to the stair builder mode with the two lines selected and select the auto curve tab. Set the inner and outer vertex multiplier to the value of your choosing (I personally use 12 on each side). This creates a perfect circle out of 2 semi-circle sectors. 0 Share this post Link to post
Phml Posted July 16, 2010 ^ Even the above seems a bit complicated to me. I just draw a linedef, curve it at a 180° angle, copypaste the result and flip it. 0 Share this post Link to post
boris Posted July 16, 2010 Phml said:^ Even the above seems a bit complicated to me. I just draw a linedef, curve it at a 180° angle, copypaste the result and flip it. Still too complicated ;) Use the make circle plugin! 0 Share this post Link to post