Jump to content
Search In
  • More options...
Find results that contain...
Find results in...
Breeder

Multi Floor Ceiling Height Adjust in Builder?

Recommended Posts

Is it possible under DOOM Builder 2 or GzDOOM Builder to select a bunch of sectors at once and auto adjust all ceiling/floor heights by 128/256/ etc.?

Share this post


Link to post

Select your sectors in 2D mode, open their properties, then enter ++128 in the floor (and/or ceiling) height field. This will raise the floors (and/or ceilings) of the selected sectors by 128 pixels. --128 to lower them.

In 3D mode: select the surfaces you want to move, then use mouse wheel to lower or raise them. Holding shift while doing so will move the surfaces 1 pixel at a time (instead of 8 pixels).

Share this post


Link to post

In recent versions of GZDB there is a field in which a value can be entered
when ceiling/floor should change by the same amount.

Spoiler

Also, sectors highlighted in one view will be highlighted in the other view.

Share this post


Link to post

You can also select a bunch of sectors in sector mode and use the mouse scroll wheel to move the ceilings/floors up and down in 8 unit increments. Hold ctrl for floor and shift for ceiling.

Share this post


Link to post

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×