Magophl Posted July 19, 2017 It's possible to move this to the floor? https://prnt.sc/fxpjr3 0 Share this post Link to post
scifista42 Posted July 19, 2017 (edited) Give the linedef a "Lower unpegged" flag. Note that the flag affects both the middle and lower texture of the linedef. Alternatively, give the linedef an appropriate y offset. 1 Share this post Link to post
Magophl Posted July 19, 2017 1 minute ago, scifista42 said: Give the linedef a "Lower unpegged" flag. Note that the flag affects both the middle and lower texture of the linedef. Thank you very much 0 Share this post Link to post
Empyre Posted July 19, 2017 If you wanted it lower than the ceiling, but not on the floor, you could use the Y offset. That would work here, too, but Lower Unpegged is easier. The Y offset method might come in handy for you in the future, though. 0 Share this post Link to post